|
This handy 3 piece system is bolted to your skinning table. The steel base is designed to hold two interchangeable hardwood fleshing beams that slip down over the V-Shaped support. There is one beam for muskrat and one beam for mink. A very good system. Comes with bracket. |
|
|
Ok, But nothing great |
10/23/2015 |
I use the mink board just because that is the only way to flesh a mink, still wish it was not so flat though. However, I do not like the muskrat board. It is to flat with too square of edges. The knife I am using is a Green English 15 knife and I end up tearing at the edges of the board. I really wish the boards had more curvature, right now all they are is a flat board cut with a taper and then slightly routerd on the edge to round it. |
- J K, ND |
|
|