Home  /   Hardware  /  Stakes and Drags  /  Super Stakes

Heat Treated Driver

Heat Treated Driver
Images/heaD2.png Images/heatD.png Images/heatD1.png
Item Number: HDRIV-01
 Review Average:  
 Number of Reviews: 7
 View Reviews | Review this item
Unit Price: $26.95
In Stock
Quantity 



BrandStake Driver

 Detailed Description

This driver is heat treated and the tip will not mushroom when used by the hardest long liner. Works on both Original and Finned Super Stakes. Driver is a hair under 2 feet from tip to tip. This measurement includes the nut on top.

Total driver length is 2 feet.

This driver will only work for the Original and Finned Super Stake Ends.

 Product ReviewsClick here to review this item
This is the one to buy 12/31/2017
I have used this driver hard this year in rocky ground hard pan and frozen sand on a lot of sets and it is still going strong.I am using a 5 plus pound hammer until the ground freezes then i go to an 8 pound sledge and it handles that just fine. Would have given it another star if it had a better way to get it back out of the ground. I did put a washer between the nut and the hex shaft and it lasted for a while then the washer broke so i welded a big thick washer on the nut and its working very well .
- TC, NE
 
Good product! 11/20/2016
I love this driver. You can whomp the tar out of it in very hard ground and it doesnt flinch. The only thing I dont like is that its very hard to get out without a T on it. Other than that, its a winner!
- Curt Brown, PA
 
Good Driver 9/20/2016
Purchased 3 of these for last season - I use this driver with Super Stakes and am very happy with performance. Worth the price!
- Stephen Zimmer, PA
 
Worth the cost!! 5/10/2016
This is a serious driver. Tough is more like it as I use it with my MB Finned stakes. This will never bend, and I am in a harder ground. The nut prevents mushrooming and the tip doesnt get stuck, so in actuality, it is the best driver on the market. 2 thumbs up!!
- John B., PA
 
Nice, but far from perfect 11/20/2015
Not a bad driver, but it is not perfect. It needs a bigger nut or some type of handle or cross-brace on the top. It is difficult to pull this driver back out of the ground after you drive in your anchor. Normally I hook my hammer under the nut or washer to pull out my driver, but this nut is so small, my hammer slips off when pulling the driver back out. A big washer or some type of handle is needed.
- Jake, ID
 
This stake driver works. 6/15/2013
The top of the stake has a nut that is threaded on. The nut eliminates the mushrooming from heavy pounding. I always hated the sharp burs from the mushrooming. The tip has been heat treated which eliminates mushrooming. Nothing more frustrating than the stake tip getting stuck in the anchor. If you use super stakes this is the driver you need.
- Darren Grefe, MN
 
Dependable 6/13/2013
Out of the several drivers I have used this is the BEST. I use this in heavy clay soil to pound my stakes. I will also use the driver to make my dirt holes. I am on my third year of using the same driver. I have used several different types and this one has out performed them all.
- JASON GEER, MT
 

You may also like:

MB Chain Stakes Original - Per Dozen
MB Chain Stakes Original - Per Dozen
$30.95
Super Stake Puller- Each
Super Stake Puller- Each
$27.95